DRB Class 42
Class 42 in BEM Nördlingen
Type and origin
Builder
Build date1943 – 1949
Total produced935
Specifications
Configuration:
  Whyte2-10-0
  GermanG 56.17
Gauge1,435 mm (4 ft 8+12 in)
Leading dia.850 mm (33+12 in)
Driver dia.1,400 mm (55+18 in)
Length:
  Over beams23,000 mm (75 ft 5+12 in)
Axle load17.6 t (17.3 long tons; 19.4 short tons)
Adhesive weight85.5 t (84.1 long tons; 94.2 short tons)
Service weight96.6 t (95.1 long tons; 106.5 short tons)
Tender type2′2′ T 30 and 2′2′ T 32
Fuel capacity10 t (9.8 long tons; 11.0 short tons) coal
Water cap.30.0 and 32 m3 (1,060 and 1,130 cu ft)
Boiler pressure16 kgf/cm2 (1.57 MPa; 228 lbf/in2)
Heating surface:
  Firebox4.70 m2 (50.6 sq ft)
  Evaporative199.54 m2 (2,147.8 sq ft)
Superheater:
  Heating area75.68 m2 (814.6 sq ft)
Cylinders2
Cylinder size630 mm (24+1316 in)
Piston stroke660 mm (26 in)
Train heatingSteam
Auxiliary brakeYes
Parking brakeYes
Performance figures
Maximum speed80 km/h (50 mph)
Indicated power1,618 kW (2,200 PS; 2,170 hp)
Career
NumbersDRG 42 001…2810, 42 0001 + 42 0002
Retired1969

The DRB Class 42[note 1] was a type of steam locomotive produced for the Deutsche Reichsbahn. It is one of the three main classes of the so-called war locomotives (Kriegslokomotiven), the other two being class 50 and 52.

Seventy of the class were captured during World War II by the Soviet Union; under Russian ownership they were given the classification TL (ТЛ).[1]

History

These engines, built from 1943 onwards, were the second heavy locomotive class of this type after the DRG Class 52. They were built for duties on routes that were cleared for a higher axle load, because they were more economical there than the KDL 1 Kriegslokomotiven of Class 52. In principle they were slimmed down 44s. The Class 42 was procured as Kriegslokomotive KDL 3.

The total of 859 units had a number of improvements to the driving and running gear. Originally it was intended to build very large numbers of these engines, but the end of the Second World War put paid to that. A condenser locomotive, based on the Class 42 was also planned, but did not come to fruition.

At the end of the war there were still half-finished engines in the workshops. So after 1945, 16 engines were built for the Reichsbahn in the western zone by the Maschinenfabrik Esslingen ('Esslingen Locomotive Works'). 126 engines were built by Polish factories for the PKP in Poland as Class Ty43 and three ex DRG engines also went over to the PKP as Class Ty3. Another 76 units were produced by the Lokomotivfabrik Floridsdorf in Vienna. These were not built for the Austrian Federal Railways (ÖBB), but were sold in 1949 to the CFL in Luxembourg - 20 engines (CFL class 55), in 1952 to Bulgarian State Railways (BDZ) - 33 pcs (BDZ class 16). and the rest to DR and various industrial enterprises in East Germany.

The majority of the locomotives that ended up in the Deutsche Bundesbahn were stationed in the Saarland. These were taken out of service by 1960. The engines with the DR continued to work until 1968, and these with BDZ until 1988. Nowadays (2015) there are only two engines in operation - CFL 5519 and BDZ 16.27 (in service since April 2015). They are used for special and tourist trains. Another operational BDZ engine 16.01 is retired since 2013.

The DB and DR locomotives had operating numbers 42 001–2810 and 42 5000. However they did not run consecutively and there were gaps.

The engines were mainly equipped with 2'2' T 30 or 2'2' T 32 tenders.

DRG Class 42.90
Type and origin
Total produced2
Specifications
Configuration:
  Whyte2-10-0
Gauge1,435 mm (4 ft 8+12 in)
Leading dia.850 t (840 long tons; 940 short tons)
Driver dia.1,400 t (1,400 long tons; 1,500 short tons)
Axle load17.6 t (17.3 long tons; 19.4 short tons)
Adhesive weight87.1 t (85.7 long tons; 96.0 short tons)
Service weight98.7 t (97.1 long tons; 108.8 short tons)
Water cap.30.0 m3 (1,060 cu ft)
Boiler pressure16 bar (1,600 kPa; 230 psi)
Heating surface:
  Firebox3.90 m2 (42.0 sq ft)
  Evaporative215.18 m2 (2,316.2 sq ft)
Superheater:
  Heating area63.50 m2 (683.5 sq ft)
Cylinders2
Cylinder size600 mm (23.62 in)
Piston stroke660 mm (25.98 in)
Performance figures
Maximum speed80 km/h (50 mph)
Indicated power1,199 kW (1,608 hp)
Career
NumbersDB 42 9000–9001
Retired1960

DB Class 42.90 (Franco-Crosti locomotive)

In 1952, the firm of Henschel rebuilt locomotives 52 893 and 52 894 with Franco-Crosti economisers (Abgasvorwärmer). Because of the resulting higher axle load, the engines were classified by the Deutsche Bundesbahn as Class 42.90 locomotives and given the operating numbers 42 9000 and 42 9001.

Engine number 42 9000 was stabled in Bingerbrück and retired in 1959. In 1960 the second one, stationed in Oberlahnstein, was taken out of service. The experience accumulated with these very economical locomotives was used in the 31 engines of Class 50.40.

Both locomotives were coupled with 2'2' T 30 tenders.

Notes

  1. Wartime locomotives classes are prefixed DRB (Deutsche Reichsbahn) to distinguish them from those introduced by the DRG (prefixed DRG), which became defunct in 1937, and those introduced later by the East German Deutsche Reichsbahn (prefixed DR).

See also

References

  1. Грузовые паровозы, захваченные в 1939-1945 гг. [Freight locomotives captured between 1939 and 1945]. scado.narod.ru (in Russian).
  • Gottwaldt, Alfred B. Deutsche Kriegslokomotiven 1939 - 1945 (in German). Transpress. ISBN 3-344-71032-X.
  • Weisbrod, Manfred; Müller, Hans; Petznik, Wolfgang (1978). Dampflokomotiven deutscher Eisenbahnen, Baureihe 41–59 (EFA 1.2) (in German) (3rd ed.). Düsseldorf: Alba. pp. 19–24. ISBN 3-87094-082-4.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.