Low-Pressure Phase

Construction on the Low-Pressure Building began in the middle of the 1910s, although several expansions were carried out until 1930. The building had early Modernist style architectural elements. It had an iron structure with the characteristic brick cladding, which was used in the High-Pressure Building as well.

The old Boiler Room is made up of four industrial naves, three of them identical and the fourth on a larger scale, covered with gable roofs creating a single diaphanous space inside. On the eastern side, and placed across these, there are two more naves that follow the same modernist aesthetic, although the furthest nave (the substation's building) doesn't have a gable roof.

The relatively low facades stand out due to their large vertical windows finished with semi-circular arches. Above these, a kind of pediment with an accented trim and a lintel closes the space. Under all this, a flat base where the brick is hidden, decorated with low arch frames simulating openings, “supports” the rest of the entire facade.

Machinery Room building (left).

The Machinery Room's facade displays the most decorative motifs and modernist elements, similar to the original Tejo Power Station and most of the electric power stations at the time. At its base, there are some differences in comparison with the other facades. The wall is covered in carved stone, except for the lower layers which are in unfinished stone, and above the arched openings, a keystone.

At the brick level, there are also three large windows that finish in semi-circular arches, the middle window being a little larger than the others, and a continuous frame with a keystone at the top of the arches, which spans the entire facade to the building's sides. The top of the facade, also formed by a broken pediment, displays decorative frames made from brick, simulating Lombard bands. On the facade's extremities, pilasters that originate at the base rise to the pediment, reminiscent of two small towers on church facades.

The longitudinal facades display a harmonious composition divided into three areas separated by large pilasters. Each of these areas has three large vertical windows adorned with a continuous frame that spans the entire side. Above each of these windows there is a smaller square window, a kind of frieze that crowns the building's side.

High Pressure Phase

High Pressure Building.

Facade details.

In the High Pressure Building, the decorative motifs are influenced by classicist aesthetic. However, the same brick cladding aesthetic is repeated. In the building's interior, similar to what is seen in the Low Pressure Boiler Room, the ceiling separating the Ash Room from the Boiler Room is covered in semi-circular vaults, with the High Pressure Building using precast concrete instead of tile similar to the Low Pressure Phase building.

The building was built in the 1940s with classical influences from Renaissance palaces as well as of the Fascist system that ruled Portugal at the time. This building, a model of iron architecture in Lisbon, sustains the entire brick cladding, the boilers, the chimneys and the water reservoir located at the top of the building. Aesthetically, the facade follows the models of a Renaissance palace, divided into base, pilasters and entablature. The main body displays large windows that end in semi-circular arches with a keystone, outlined with a frame that runs the entire length of the facade. Between the windows, there are large pilasters that span the entire facade from the bottom of the base to the top of the entablature.

The upper entablature has two independent friezes. The lower is decorated with blind arcades, marked by frames. The upper entablature displays the same organization, but with the spaces outlined by frames formed by windows. A small tower stands out in the section closer to the Low Pressure Building and, above everything else in the complex including the High Pressure boilers’ four chimneys, and at their bases, the entire smoke extraction and air recovery system.