Madrid–Seville high-speed rail line
Madrid-Seville line in red
Overview
StatusOperational
OwnerAdif
LocaleSpain
Termini
Service
TypeHigh-speed rail
Operator(s)Renfe Operadora
Ridership3,481,000 (2018)[1]
History
Opened14 April 1992
Technical
Line length471.8 km (293.2 mi)
Number of tracksDouble track
Track gauge1,435 mm (4 ft 8+12 in) standard gauge
Minimum radiusStandard: 4000 m; Absolute: 3250 m
Electrification25 kV 50 Hz
Operating speed300 km/h
Maximum inclineStandard: 12.5 ; Absolute: 13.25
Route map

km
0.000
Madrid Atocha
12.300
Sevilla-Barcelona bypass
to Valdemingomez
14.272
Los Gavilanes
24.418
Parla
28.000
35.311
Yeles
53.727
La Sagra Junction
to Toledo
63.400
704 m
73.724
Ablates
89.535
Mora Yard
104.882
Los Yébenes
119.746
Urda Yard
130.136
El Emperador
149.621
Malagón
170.748
Ciudad Real
171.000
Ciudad Real
Ciudad Real
Central Airport
Ciudad Real Central Airport
196.476
Calatrava Yard
209.761
Puertollano
225.426
Brazatortas
244.488
Venta la Inés Yard
267.343
Conquista Yard
Guadalmez
798 m
285.193
Villanueva de Córdoba
293.950
Arroyo del Valle
300.000
Piedras de la Sal
2,569 m
304.800
Churretes Bajos
317.796
Adamuz
345.184
Córdoba
to Málaga
(Iberian gauge)
Guadalquivir
358.006
362.958
Almodovar del Río
387.149
Hornachuelos Yard
408.927
Peñaflor
426.144
Guadajoz Yard
Guadalquivir
442.719
Cantillana Yard
460.461
Majarabique
to Majarabique
(Iberian gauge)
Seville-Santa Justa
km

The Madrid–Sevilla high-speed line (NAFA or Nuevo Acceso Ferroviario a Andalucía) is a 472-kilometer-long (293 mi) Spanish railway line for high-speed traffic between Madrid and Seville. The first Spanish high-speed rail connection has been in use since 21 April 1992 at speeds up to 300 km/h (186 mph). Travel time between the two end points was reduced by over half.

At Córdoba the Madrid–Málaga high-speed rail line leaves the line from Madrid. At Seville the line is extended to Cádiz only for the Alvia service.[2]

Routing

AVEs in Seville's Santa Justa station.

The line starts at Madrid-Atocha and runs over 31 bridges (total length 9,845 meters (32,300 ft)) and through 17 tunnels (total length 16.03 kilometers (9.96 mi),[3] crossing the plains of the southern half of the Inner Plateau. It climbs south of Toledo as well as when crossing the Sierra Morena to an altitude of 800 metres (2,600 ft), and then descends to around sea level as it approaches Seville. The terminus of the line is the new railway station Santa Justa in Seville.

Technical details

The high-speed line was constructed at standard gauge, in contrast with the rest of the Spanish railway network. Voltage is 25 kV AC instead of 3000 V DC. Twelve transformers feed the overhead wires. Some 8 kilometers (5.0 mi) before the start and end points of the line, the line merges with local DC tracks.

The line was equipped with signalling standards that had been developed in the 80s for the German Hanover-Würzburg high-speed rail line and the Mannheim-Stuttgart high-speed rail line.

At the end of 2006, Spanish governmental agency ADIF ordered technical changes to the safety systems along the line for an amount of €12.6 million, so that in the future, trains of the RENFE-type 104 will be able to run at 200 km/h (124 mph) instead of 180 km/h (112 mph). A further amount of €4.1 million has been spent on changes to the ASFA train safety system.[4]

Between the railway stations along the line, passing stations and emergency stations are located (in Spanish: Puesto de adelantamiento y estacionamiento de trenes, abbr. PAET). These allow faster trains to overtake slower trains, and the parking of rescue trains. In addition, most of these stations have basic platforms that can be used to let passengers descend and change to buses in case of emergency.

Trains travel along the line at 300 km/h (186 mph) during the sections of the track close to Madrid. They travel at 200 km/h (124 mph) through the Sierra Morena region, possibly because the S/100 trains aren't pressure-sealed and this section includes many tunnels and also because of the tight curvatures in the Sierra Morena (occasionally dipping as low as 2,300 m (7,500 ft)[5]). According to the HS2 website,[6] a 200 km/h (124 mph) track needs a curvature of 1,800 m (5,900 ft) and a 400 km/h (249 mph) track needs a curvature of 7,200 m (23,600 ft). As the necessary curvature increases in proportion to the square of the maximum velocity, the maximum safe speed for a curvature of 2,300 m (7,500 ft) would be 226 km/h (140 mph), assuming no tilting technology: - only the AVE Class 100, AVE Class 102 and AVE Class 103 run through the Sierra Morena section, of which only the AVE Class 102 has tilting technology. The trains travel at a top speed of 250 km/h (155 mph) between Córdoba and Seville, possibly on account of the AVANT services that also use the line, whose trains are limited to 250 km/h (155 mph). On most journeys, the trains spend a very small proportion of the journey travelling above 250 km/h (155 mph), although most of the Málaga branch is done at 300 km/h (186 mph) (save for station approaches and the Gobantes and Abdalajís tunnels). The trains slow down to approximately 160 km/h (99 mph) when travelling through Ciudad Real station. They also have to slow down to 70 km/h (43 mph) when travelling through Puertollano station because of the lack of a bypass route and tight curvatures in the station.

History

AVE lines in Andalusia, including the later branch to Malaga.

On 11 October 1986 the Spanish government decided to build a new railway between Madrid and Seville. On 25 February 1988, the international tender for the acquisition of 24 high-speed trains AVE followed; these trains were ordered by 23 December 1988. The first train, based on the third generation of TGVs, was delivered on 10 October 1991.

In December 1988 it was decided to build the new line in standard gauge. Construction was ordered on 16 March 1989, and it lasted for 33 months; actual construction activity lasted only 24 months. Commercial use of the line commenced on 21 April 1992. In the first weeks, over 23 thousand passengers used the new trains - an occupancy rate of 81%.

On 20 April 1992, services started between Madrid and Seville. Non-stop travel time between the two cities were 2:45 hrs; with stops at Ciudad Real, Puertollano and Córdoba it was 2:55 hrs. In 1992, tickets cost around 50-70 euros in second class, in first class over 100 euros.

In 2014, a new station was added in Villanueva de Córdoba, between Córdoba and Puertollano, to improve accessibility of the Los Pedroches region.

The line later received branches in Andalusia. In October 2015 an extension of the Madrid-Seville high-speed rail line to Cádiz railway station was completed after 14 years of works and put in service by Alvia trains for speeds up to 200 km/h (124 mph).[2]

Impact

The new railway line radically changed the modal split between Madrid and Seville. The share of air traffic decreased between 1991 and 1994 from 40% to 13%; the combined share of car and bus decreased from 44% to 36%. The share of railway traffic increased from 16% to 51%, while total traffic increased by 35%.[7]

In 1997, some 4.4 million passengers travelled along the line; in 1998, 4.75 million. By 1999, trains transported over 4 times as many passengers as planes between Seville and Madrid.[3]

Sources

  • Hochgeschwindigkeitsverkehr in Spanien aufgenommen and Neubaustrecke Madrid–Sevilla in Betrieb, in: Eisenbahntechnische Rundschau, June 1992, page 354 f. (in German)

References

  1. "El número de viajeros del AVE Madrid-Sevilla creció un 5,5% en 2018". El Correo Web (in Spanish). 30 January 2019. Retrieved 30 August 2019.
  2. 1 2 "Fomento culmina la obra de alta velocidad entre Sevilla y Cádiz". lavozdigital.es (in Spanish).
  3. 1 2 Spanish To Build More High-Speed Lines. International Railway Journal, Sept. 1999.
  4. High speed advances in Spain. In: Railway Gazette International. 163, nr. 1, 2007, ISSN 0373-5346, page 4
  5. "Adif - Madrid - Seville line". Archived from the original on 2010-04-12. Retrieved 2010-03-24.
  6. "About High Speed Rail". Archived from the original on 2010-03-14. Retrieved 2010-03-24.
  7. Moshe Givoni: Development and Impact of the Modern High-speed Train: A Review. In: Transport Reviews. 26, Nr. 5, Jahr, ISSN 0144-1647, S. 593–611

Further reading

  • Haydock, David (22 February – 7 March 1990). "Around Europe: Spain". RAIL. No. 116. EMAP National Publications. p. 19. ISSN 0953-4563. OCLC 49953699.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.