12-gauge
TypeShotgun
Specifications
Overall length2.75 inches (7.0 cm)

Military use of combat shotguns through the 20th century has created a need for ammunition maximizing the combat effectiveness of such weapons within the limitations of international law. 12-gauge has been widely accepted as an appropriate bore diameter to provide an effective number of projectiles within an acceptable recoil. Early 12-gauge popularity for sporting purposes produced a large number of repeating firearms designs readily adaptable to military purposes.[1]

United States

While shotguns had been used in earlier conflicts, the trench warfare of World War I demonstrated a need for standardized weapons and ammunition.[2] Initial issue with each shotgun was one hundred commercial-production paper-cased shotgun shells containing nine 00 buckshot pellets 0.33 inches (8.4 mm) in diameter. These cartridges became wet in the muddy trench warfare environment; and swelled paper cases would no longer chamber reliably. Full-length brass cartridges proved more resistant to moist field conditions and the repeated loading and unloading during patrols and watches when no ammunition was fired. Some of these early brass cartridges had an unusual saw-tooth crimp.[3]

M19

World War II production of full-length brass cartridges containing 00 buckshot was designated Shell, shotgun, brass, 12 gauge, No. 00 buckshot, M19.[1]

M162

Plastic shotgun shells devised following World War II were equally durable and water resistant as the earlier brass cartridges and had the additional advantages of corrosion resistance and lower cost. Initial production for the Vietnam War loaded 00 buckshot into the same red plastic cases being used for sporting ammunition and was designated: Shell, shotgun, plastic case, 12 gauge, No. 00 buck, XM162. The shells were typically packaged as twelve ten-round cardboard boxes within a metal ammunition box.[1]

M257

Combat experience in Vietnam suggested two improvements. Heavy bullet preferences dating back to the Philippine–American War were re-evaluated considering combat experience with the 5.56×45mm NATO cartridge, and advantages of a larger number of smaller No. 4 buckshot pellets were evident for some situations. These loadings were designated: Shell, shotgun, plastic case, No. 4 buck, special, XM257. Initial production was in the same red plastic cases, but the visibility advantage for sporting use was a liability in jungle warfare; so later production used cases of a subdued green color.[1]

Flechettes

Plastic cases loaded with small steel darts called "flechettes" were issued on a limited trial basis during the Vietnam war. Cartridges manufactured by Western Cartridge Company contained twenty flechettes 18.5 millimetres (0.73 in) long and weighing 7.3 grains (0.47 g) each. The flechettes were packed in a plastic cup with granulated white polyethylene to maintain alignment with the bore axis, and supported by a metal disk to prevent penetration of the over-powder wad during acceleration down the bore. Cartridges manufactured by Federal Cartridge Company contained 25 flechettes. Tips of the flechettes are exposed in the Federal cartridges, but concealed by a conventional star crimp in Western cartridges.[4] Flechettes had flatter trajectory over longer ranges than spherical buckshot, but combat effectiveness did not justify continued production.[5]

Experimental

FRAG-12 is experimental military shotgun grenade ammunition under consideration by military forces.[6] Coming in three variants: High explosive (HE), high explosive armor-piercing (HEAP) and high explosive fragmenting antipersonnel (HEFA) used by the AA-12 Atchisson Assault Shotgun and potentially other shotguns.[7][8][9]

References

  1. 1 2 3 4 Canfield, Bruce N. (March 2002). "Combat Shotguns of the Vietnam War". American Rifleman: 44–47 & 92–95.
  2. "Shotguns". GlobalSecurity.org. Retrieved 25 September 2022.
  3. Canfield, Bruce N. (May 2004). "Give Us More Shotguns!". American Rifleman: 58–63.
  4. Di Maio, Vincent J.M. (1999). Gunshot Wounds (Second ed.). Boca Raton, Florida: CRC Press. p. 320. ISBN 0-8493-8163-0.
  5. Canfield, Bruce N. (July 2015). "Vietnam-Era Military Shotshells". American Rifleman: 44.
  6. "FRAG-12 Factsheet" (PDF). Marine Corps Warfighting Laboratory. 5 August 2005. Archived from the original (PDF) on 13 April 2008.
  7. Beachey, Anthony (12 January 2011). "High Explosive: Innovations in Ammunition". Army Technology.
  8. Crane, David (15 June 2005). "Auto Assault-12 (AA-12) Full-Auto Machine Shotgun/FRAG-12 High-Explosive Round Combo/Weapon System!". Defense Review.
  9. "The AA-12 shotgun". YouTube.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.